Parts List (Step 1)

Here you can find the detailed parts list of your HydroBot

Circuits and Electronics:

  • Raspberry Pi Zero W
  • Whitebox Labs Tentacle T3 for Raspberry Pi (with pH, EC and Temperature Stamps)
  • Arduino Leonardo
  • Arduino Grove – Base Shield V2
  • Motor Shield for Arduino
  • Grove – 433MHz Simple RF link kit
  • Grove – Temperature and Humidity Senor (DHT11)
  • Two DC Micro Self-Priming Peristaltic Pumps

Chords, Adapters and Wires:

  • 5V AC/DC Power Adapter USB A
  • 6 ft USB A Male to Female (extension chord)
  • USB A to Micro USB 90º angle (one left turn and on right turn)
  • 9V AC/DC Power Adapter For Arduino
  • USB A Female to USB B Male Adapter
  • Grove – Universal 4 Pin 20cm Unbuckled Cable (three included)

Screws, Nuts and Spacers

  • This section is under construction


  • Custom made laser cut acrylic case (with four rubber pads)
  • Five Etekcity Remote Control Wireless Outlets (433 MHz)
  • Four pieces of 1 ft long food grade tubing for peristaltic pumps

    If you have all of your parts, you’re ready to continue! WiFi Setup is next